4024-XXX
Sub paddle drive shaft assembly removal
1.
Open the finisher front door assembly.
2.
Remove the rear upper cover. See
3.
Remove the media eject unit assembly. See
4.
Loosen the screw securing the knob (A) to the sub paddle drive shaft assembly (B) on the front of the
finisher.
5.
Remove the knob (A).
6.
Remove the one e-clip securing the sub paddle drive shaft assembly (B).
7.
Remove the bushing (C).
4-64
Finisher Service Manual
"Rear upper cover removal" on page
"Media eject unit assembly removal" on page
B
Front
4-24.
C
E-clip
Screw
A
4-59.