Lexmark W840 Finisher Service Manual page 247
Hide thumbs
Also See for W840 Finisher:
- Service manual (493 pages) ,
- User manual (119 pages) ,
- Connection manual (19 pages)
Table of Contents
Advertisement
5.
Remove the two screws securing the bracket (D) to the finisher.
6.
Remove the bracket (D).
7.
Remove the two screws securing the bracket (D) to the drive motor (entrance/paddle) (C).
8.
Remove the drive motor (entrance/paddle) (C).
9.
Remove the belt (entrance/paddle) (B).
Replacement notes:
•
The tension of the belt (entrance/paddle) (B) is automatically adjusted by the force of the spring attached to
the belt tensioner bracket (A).
•
Tighten the two screws in the order shown.
4024-XXX
D
C
Repair information
4-101
Advertisement
Table of Contents
