Sensor (Media Eject Shaft Hp) Removal - Lexmark W840 Finisher Service Manual

Sensor (media eject shaft HP) removal

1.
Remove the rear upper cover. See
2.
Disconnect the connector from the sensor (media eject shaft HP) (A).
3.
Rotate the media eject clutch actuator (B) by hand so it clears the sensor (media eject shaft HP) (A).
4.
Release the hooks securing the sensor (media eject shaft HP) (A) to the bracket (C).
5.
Remove the sensor (media eject shaft HP) (A).
"Rear upper cover removal" on page
B
C
A
4024-XXX
4-24.
Rear
Repair information
4-79