Removal Procedures; Bridge Unit Assembly Removal - Lexmark W840 Finisher Service Manual

4024-XXX

Removal procedures

CAUTION: Remove the power cord from the printer or electrical outlet before you connect or
disconnect any cable or electronic board or assembly for personal safety and to prevent damage to
the printer. Disconnect any connections between the printer and PCs/peripherals.
Note: Some removal procedures require removing cable ties. You must replace cable ties during reassembly to
avoid pinching wires, obstructing the paper path, or restricting mechanical movement.

Bridge unit assembly removal

1.
Release the hook securing the bridge unit hookup cover (A) to the finisher.
2.
Remove the bridge unit hookup cover (A).
Right
3.
Remove the finisher from the printer. See
4.
Remove the two screws securing the bridge unit assembly (B) to the printer.
4-2
Finisher Service Manual
Hook
Rear
"Finisher removal" on page
A
4-4.