Media Eject Shaft Assembly Removal - Lexmark W840 Finisher Service Manual

4024-XXX

Media eject shaft assembly removal

1.
Remove the finisher front door assembly. See
2.
Remove the rear upper cover. See
3.
Move the slip clutch gear 24T (A) toward the rear as shown to disengage the stacker bin (B).
4.
Move the stacker bin down as shown to its lowest position after being disengaged.
Note: Make sure the stacker bin is at its lowest position before continuing.
5.
Remove the upper media bin assembly. See
6.
Remove the four screws securing the right panel (C) to the finisher.
C
7.
Remove the media eject motor assembly. See
8.
Release the hook of the media eject shaft gear 39T (D) from the media eject shaft assembly (E).
9.
Remove the media eject shaft gear 39T (D).
10.
Remove the 6 mm bushing (F).
11.
Remove the e-clip with a prying tool securing the media eject shaft assembly (E) to the rear of the finisher.
12.
Remove the 8 mm bushing (G).
13.
Remove the two e-clips securing the media eject shaft assembly (E) to the front of the finisher.
14.
Remove the 6 mm bushing (F) and the 8 mm bushing (G).
4-74
Finisher Service Manual
"Finisher front door assembly removal" on page
"Rear upper cover removal" on page
"Stacker media bin assembly removal" on page
B
"Media eject motor assembly removal" on page
4-24.
A
Rear
4-27.
4-22.
4-78.