Sensor (Compiler Media In) Static Jam - Lexmark W840 Finisher Service Manual

4024-XXX
Step Check
3 Check the media eject motor connection.
Is the above motor connected properly?
4 Check the compiler media in actuator for correct
operation.
Is the actuator operating correctly?
5 Check the sensor (compiler media in) for correct
operation.
Perform the Compiler media in test.
1. Enter Diagnostics mode.
2. Select FINISHER TESTS.
3. Select Sensor Tests.
4. Select Media Path1.
5. Select Compiler media in.
Does the display on the operator panel change every
time the compiler media in actuator of the sensor
(compiler media in) is operated?
6 Check the sensor (compiler media in) connection.
Are the connections of the compiler unit cable
assembly properly connected?
7 Perform a test print. Does the error still occur?

286.00 Sensor (compiler media in) static jam

Step Check
1 Check the eject clamp motor for correct operation.
Check the above motor by opening the finisher front
door assembly and then closing it.
Does the eject clamp motor rotate normally?
2-38
Finisher Service Manual
Yes No
Disconnect then Replace the
reconnect the connection.
connector P8304
on the finisher
controller card
assembly.
Perform a test
print, if the error
still occurs
replace the
media eject
motor assembly.
Go to step 5. Reinstall the
compiler media in
actuator. See
"Sensor
(compiler media
in) removal" on
page
Go to step 7. Go to step 6.
Replace the Replace the
sensor (compiler connection.
media in). See
"Sensor
(compiler media
in) removal" on
page 4-73.
Replace the Problem solved
finisher controller
card assembly.
See "Finisher
controller card
assembly
removal" on
page 4-118.
Yes No
Go to step 3. Go to step 2.
4-73.