Media Eject Unit Assembly Removal - Lexmark W840 Finisher Service Manual

Media eject unit assembly removal

1.
Remove the finisher front door assembly. See
2.
Remove the rear upper cover. See
3.
Remove the upper media bin assembly. See
4.
Remove the upper media bin vertical cover. See
5.
Remove the two media eject unit springs (A) by pushing them downward.
6.
Disconnect the connector from the eject unit solenoid (B).
7.
Release the harness from the two clamps.
"Rear upper cover removal" on page
A
Right
B
"Finisher front door assembly removal" on page
"Upper media bin assembly removal" on page
"Right eject cover removal" on page
Harness clamp
A
4024-XXX
4-27.
4-24.
4-20.
4-21.
4-59
Repair information