Media Eject Clamp Motor Assembly Removal - Lexmark W840 Finisher Service Manual

4024-XXX

Media eject clamp motor assembly removal

1.
Remove the rear upper cover. See
2.
Remove the upper media bin assembly. See
3.
Remove the two media eject unit springs (A) attached to the media eject unit assembly (B) by pushing
them downward.
4.
Disconnect the connector from the media eject clamp motor (C).
5.
Disconnect the connector from the sensor (media eject clamp HP) (D).
6.
Remove the three screws securing the bracket (E) to the finisher.
7.
Remove the bracket (E).
Note: When removing the bracket, turn the media eject clamp gear 70T (F) so that it does not interact with
the sensor (media eject clamp HP) (D).
Rear
8.
Remove the two screws securing the media eject clamp motor to the bracket (E).
9.
Remove the media eject clamp motor (C).
Replacement note: When replacing the bracket, turn the media eject clamp gear 70T (F) so that it interacts with
the sensor (media eject clamp HP).
4-66
Finisher Service Manual
"Rear upper cover removal" on page
"Upper media bin assembly removal" on page
Right
A
4-24.
B
F
D
4-20.
E
C