Sensor (Bridge Unit Media Entrance) Removal - Lexmark W840 Finisher Service Manual

4024-XXX

Sensor (bridge unit media entrance) removal

1.
Remove the bridge unit assembly. See
2.
Place the bridge unit assembly upside down.
3.
Remove the screw securing the bracket (A) to the bridge unit assembly (B).
4.
Disconnect the connector from the sensor (bridge unit media entrance) (C).
5.
Release the hooks securing the sensor (bridge unit media entrance) (C) to the bracket (A).
6.
Remove the sensor (bridge unit media entrance) (C).
4-16
Finisher Service Manual
"Bridge unit assembly removal" on page
C
4-2.
A
B