Bridge Unit Left Shaft Assembly Removal - Lexmark W840 Finisher Service Manual

4024-XXX

Bridge unit left shaft assembly removal

1.
Open the bridge unit top cover assembly.
2.
Use a prying tool to remove the front e-clip securing the 4 mm ball bearing (A) to the bridge unit left
shaft (B).
3.
Move the bridge unit left shaft (B) rearward as shown.
4.
Remove the bridge unit left shaft (B) from the two transport belts (C).
5.
Remove the bridge unit left shaft (B).
6.
Remove the other e-clip securing the 4 mm ball bearing (A) on the other end of the shaft.
7.
Remove the second 4 mm ball bearing (A) from the bridge unit left shaft.
4-10
Finisher Service Manual
C
B
Front
A