Default Settings (Factory Settings) - Reset - Gossen MetraWatt METRAHIT ENERGY TRMS System Multimeter Operating Instructions Manual

Device and Measuring Parameters
Actual measurement is always executed using the sampling rate
selected in "Store > rAtE".
MEASURE
1nFo   store
...
SETUP
FUNC
trig set : sto-ou / sto-in / off
ENTER
FUNC
l_trig set : -300000 ... +300000
ENTER
FUNC
h_trig set : -300000 ... +300000
ENTER
tStorE – Recording Time (parameter for memory mode operation)
This parameter determines whether or not measured values will be
recorded for a limited time only. If recording time will be limited, its
duration can be entered in hours, minutes and seconds. "On"
means unlimited recording time.
MEASURE
1nFo   store
...
SETUP
FUNC
t .store set : on /99:00:00 (hh:mm:ss)
ENTER
74
FUNC
  trig
...
ENTER


FUNC

ENTER
FUNC
  t .store
...
ENTER
FUNC

ENTER
6.5 Default Settings (factory settings) – Reset
Previously entered changes can be undone, and default settings
can be restored. This may be advisable under the following cir-
cumstances:
• After the occurrence of software or hardware errors
• If you are under the impression that the multimeter does not
work correctly
Ð Disconnect the device from the measuring circuit.
Ð Remove the batteries temporarily (see also section 9.2).
Ð Simultaneously press and hold the
keys, and connect the battery at
the same time.
ZERO ON / OFF
and
ESC LIGHT
GMC-I Messtechnik GmbH