Oki OKIOFFICE84 Maintenance Manual page 90

Table 2.9.4 (2/5) User's Initial Settings (One-touch key Program)
F+OT
Item
No.
6 Report printing
7 Selection of Counter display
40672201TH Rev. 4
Specifications
The report print in 6 items are as follows:
1. Activity report
2. Broadcast message confirmation report
(Multi location)
3. Activity memory files report
4. Phone directory report
5. Configuration list without service default
(Service default report if service bit sets to ON.)
6. Protocol dump list
7. Log report (Set to on Service bit)
* Refer to Reports and Lists of Chapter 1.
The operation for displaying and clearing the print counters
in five ways are as follows:
1. Drum counter
When I/D unit reaches run-out time, "CHANGE DRUM"
is appeared in LCD. Under above condition, user can
see the Drum message and clear. However, No. of
counter is not shown for user (Service bit=OFF). After
user changed the Drum and clear operation, "CHANGE
DRUM" in LCD is displayed. However, the drum counter
clear is possible even if the drum is not at the end of its
lifespan.
2. Toner counter
This counter provided to serviceman to check the num-
ber of toner counter.
When srvice bit=OFF, this counter message is skipped.
When service bit=ON, this counter is cleared by opera-
tion.
When TF32=ON, this counter is cleared by operation
without Service bit ON/OFF (TF01). (User can clear the
toner counter.)
3. Drum (T) counter
This counter to serviceman to know the total number of
DRUM counter for the machine.
When service bit=OFF, this counter message is skipped.
When service bit=ON, this counter is cleared by opera-
tion.
4. Print counter
This counter is provided to user.
Display shows how many times recording paper has
been printed.
But user cannot clear this number.
5. Scan counter
This counter is provided to user.
Display shows how many times document has been
passed the ADF.
But user cannot clear this number.
2 - 46