Oki OKIOFFICE84 Maintenance Manual page 68

T.F.
No.
22 T/F tone attenuator
(for TEL/FAX SW)
23 MF attenuator
24 Ring duration detection time
25 CML timing
26 Strobe for LED head
40672201TH Rev. 4
Table 2.9.1 (5/7) Service Personnel Initial Settings
Item
Note: The send signal power level should meet
Adjusts the attenuation (dB) for the quasi-ring
back tone send signal of TEL/FAX switching.
Adjusting value is 0 to 15 dB in one dB steps.
Adjusts the attenuation (dB) for the send MF
tone power level.
Adjusting value is 0 to 15 dB in one dB steps.
Selects the minimum ring detection time to meet
country's requirements.
Adjusting time is 100 MS to 990 MS in 10 MS
steps.
For example:
Selects the time from end of ring to CML-ON.
Adjusting time is 100 MS to 1900 MS in 100 MS
steps.
For example:
Setting of LED print head strobe signals (00000-
11111).
Selection of strobe width in LED head.
"00000" is lightest and "11111" is darkest.
Note 1: When the rank marking of the new re-
Note 2: Intensity ranking is determined by the
Specifications
your country's regulation. Some coun-
tries may specify the power level at a
telephone exchange.
In that case, you should substract the
specified level from the line cable attenu-
ation to determine the send level of your
fax.
10 to 99 selectable.
(120 ms)
12 x 10 ms = 120 ms
0 to 19 selectable.
(300 ms)
03 x 100 ms = 300 ms
placed LED print head (new part) is same
as that of the old used LED print head (old
part), you do not always have to set the
LED print head strobe signal.
first, second and third digits from the right
on the LED print head serial number.
(i.e. in .... 212, 212 is the intensity rank-
ing.)
2 - 24
Default