═════════════════════════════════════════════════════════════════
Primary Port Selection
Operates in either the Automatic mode or the Semi-Automatic mode.
This feature designates where the call is routed when tone transfer codes are not detected in the Automatic mode, or any
inbound call when the ASAP 104 is in the Semi-Automatic Mode. Calls can be designated to any of the 4 ports other than
the Secondary Primary Port Selection. Any of the 4 ports can be designated as the Primary Port. One port cannot be
designated to be both the Primary Port and Secondary Port.
The factory setting for Primary Port Selection is port P1 [ # * (three beeps) 7 1 1 * (three beeps) * (one beep) ].
To select transfer to port P2:
1. Take the phone in port P1 off-hook * (three beeps)
* (one beep)
2. Press # * (three beeps) 7 2 1 * (three beeps) *
(one beep)
═════════════════════════════════════════════════════════════════
Secondary Port Selection
Operates in either the Automatic mode or the Semi-Automatic mode.
This feature designates where the call is routed when the Automatic No Answer Transfer feature or the Primary Port
Transfer feature is activated.
The factory setting for Secondary Port Selection is port P2 [ # * (three beeps) 7 2 2 * (three beeps) * (one beep) ].
To select transfer to port P1:
1. Take the phone in port P1 off-hook
2. Press # * (three beeps) 7 2 1 * (three beeps) *
(one beep)
3. Hang up the phone
3. Hang up the phone
To select transfer to port P3, press # * (three beeps)
7 1 3 * (three beeps) * (one beep)
To select transfer to port P3, press # * (three beeps)
7 1 4 * (three beeps) * (one beep)
To select transfer to port P3, press # * (three beeps)
7 2 3 * (three beeps) * (one beep)
To select transfer to port P3, press # * (three beeps)
7 2 4 * (three beeps) * (one beep)
36