Table of Contents
Advertisement
Programming the ASAP 104
═════════════════════════════════════════════════════════════════
Introduction
The ASAP 104 has many features that can be used to customize its operation.
Many of these features have either feature settings or timing parameters associated directly with their operation.
Therefore, read the following sections carefully to obtain the best results when programming the ASAP 104.
═════════════════════════════════════════════════════════════════
Programming Locally
Connect the ASAP 104 as shown, using a tone phone.
Programming changes can be performed from a tone phone connected to port P1 of an operational unit.
To enter the programming mode, take the phone off-hook, press # * . You will hear three beeps indicating the unit
is in the programming mode
Once in programming, the ASAP 104 allows 8 seconds between tone commands before exiting the programming
mode without saving the changes. Therefore, it would be beneficial to write down all programming changes before
entering the programming mode.
Once a complete programming command is entered, it must be followed by the * key, which stores it into memory.
After you enter the * key, you can set as many features or feature settings as needed for your application. When all
programming changes are complete, press * * to save the changes to exit the programming mode. There is one
final beep when exiting programming mode before returning to a dial tone.
The ASAP 104 will not be able to process calls during programming sessions.
If during a programming session you receive a dial tone, the intercept operator message, or if programming was not
successful, perform the following steps:
1.Disconnect the telephone line from the TEL LINE port.
2.Take the phone in port P1 off-hook.
3.Disconnect power from the ASAP 104.
4.Reconnect power to the ASAP 104.
5.The ASAP 104 will produce three beeps indicating entry into the programming mode.
6.Continue with programming changes as previously described.
7.When programming changes are complete, hang up the phone.
8.Reconnect the telephone line.
NOTE: Programming changes can only
be made through port P1 even if the
Primary port is reassigned.
19
Advertisement
Table of Contents
