Automatic Ring Reduction; Automatic Ring Reduction Reset - Command Communications ASAP 104 Installation And Reference Manual

═════════════════════════════════════════════════════════════════

Automatic Ring Reduction

Operates in either the Automatic mode or the Semi-Automatic mode.
This feature is designed to activate when Automatic No Answer Transfer sends an unanswered call to the Secondary port.
After this transfer occurs, the Automatic Ring Reduction is activated and allows only 2 rings to the Primary port for future
calls. The ASAP 104 will reset the ring count to 6 rings (Ring Reduction Reset) after 10 minutes (Ring Reduction Reset
Timer) of inactivity on other ports. Otherwise, it can be reset manually from any port by making a call.
If Automatic Ring Reduction is turned OFF, the ASAP 104 will continue to allow 6 rings (Rings Available to Port P__) to the
Primary port on every call. (Turning this feature OFF may limit some fax machine's ability to connect to your fax machine due to
timing parameters.
The factory setting for Automatic Ring Reduction is OFF.
To turn this feature ON:
1. Take the phone in port P1 off-hook
2. Press # * (three beeps) 1 2 * (three beeps) * (one
beep)
3. Hang up the phone
═════════════════════════════════════════════════════════════════

Automatic Ring Reduction Reset

Operates in either the Automatic mode or the Semi-Automatic mode.
This feature is designed to reset the ASAP 104 to allow 6 rings (Rings to Ports P__) to the Primary port after the Automatic
Ring Reduction reduced the ring count to 2 rings.
The Automatic Ring Reduction Reset will reset the ring count to 6 rings after 10 minutes (Ring Reduction Reset Timer) of
inactivity. Otherwise, it can be reset manually from any port by making a call.
If Automatic Ring Reduction Reset is turned OFF, the ASAP 104 will continue to allow 2 rings to the Primary port on every
call until it is manually reset.
The factory setting for Automatic Ring Reduction Reset is ON, but will not operate until Automatic Ring Reduction is turned
ON.
To turn this feature OFF:
1. Take the phone in port P1 off-hook
2. Press # * (three beeps) 0 3 * (three beeps) * (one
beep)
3. Hang up the phone
To turn this feature OFF:
1. Take the phone in port P1 off-hook
2. Press # * (three beeps) 0 2 * (three beeps) * (one beep)
3. Hang up the phone
To turn this feature ON:
1. Take the phone in port P1 off-hook
2. Press # * (three beeps) 1 3 * (three beeps) * (one
beep)
3. Hang up the phone
24