Table of Contents
Advertisement
═══════════════════════════════════════════════════════════════
Single Tone Detection Timer
Operates in either the Automatic or Semi-Automatic mode.
This feature designates the timing parameters for operation of the Single Tone Detection feature.
When Single Tone Detection is activated, but this timer expires on a call, the ASAP 104 will not transfer calls producing
identifying tones.
This feature has a range of 4-30 seconds.
The factory setting for the Single Tone Detection Timer is 10 seconds. To change this feature, perform the following steps:
1. Take the phone in port P1 off-hook
2. Press # * (three beeps) 52 _ _ * (three beeps) * (one beep)
(Blank spaces represent new Single Tone Detection Timer setting)
3. Hang up the phone
═════════════════════════════════════════════════════════════════
Remote Security Access Code
Operates in the Automatic mode.
This feature designates the tone access code that will be required to program the ASAP 104 from a remote location.
Once entered, the ASAP 104 stores it in non-volatile memory until removed through programming.
The Remote Security Access Code can be any numeric 1-4 digits not including the # key. See Pound Key Transfer
Required for use with the Remote Security Access Code. Do not use a transfer code for a port on the ASAP 104, or 0 0 0
0 as it will disable remote programming.
The factory setting for the Remote Security Access Code is unprogrammed for your protection. It must be entered before
you can access the remote programming mode. To enter an access code, perform the following steps:
1. Take the phone in port P1 off-hook
2. Press # * (three beeps) 6 0 _ _ _ _ * (three beeps) * (one beep) (blank spaces represent the new Remote
Security Access Code)
3. Hang up the phone
═════════════════════════════════════════════════════════════════
Port P1 Transfer Code
Operates in either the Automatic mode or the Semi-Automatic mode.
This feature designates the tone access code that will be required to transfer a call to port P1.
The Port P1 Transfer Code can be any numeric 1-4 digits not including the # key. See Pound Key Transfer Required for
use with the Port P1 Transfer Code. Do not use a code that is a transfer code for another port on the ASAP 104.
The factory setting for the Port P1 Transfer Code is 1 1.
To enter a new access code, perform the following steps:
1. Take the phone in port P1 off-hook
2. Press # * (three beeps) 6 1 _ _ _ _ * (three beeps) * (one beep) (blank spaces represent the new Port
P1 Transfer Code)
3. Hang up the phone
A code of 0 0 0 0 will disable tone access.
34
Advertisement
Table of Contents
