Table of Contents
Advertisement
═════════════════════════════════════════════════════════════════
Caller ID Retransmission
This feature allows Caller ID devices to be connected to any port of the ASAP 104.
Operates in either the Automatic mode or the Semi-Automatic mode. (Caller ID requires service activation from the phone
company.) Also see the Caller ID Pass Thru section.
Operation in the Automatic mode and Semi-Automatic mode vary as follows:
Automatic mode
When the ASAP 104 is in the Automatic mode, the unit detects the incoming ring signal and receives the caller ID information
between the first and seconds rings. Before the second ring, the ASAP 104 answers and processes the call normally. The
determined port is rung and the Caller ID information is retransmitted to the port after the first ring to the port. The Caller ID
information retransmitted only 1 time. It is not retransmitted if the call is transferred from one port to another. If Distinctive
Ring Service Detection is turned ON, only the port designated by the DRS Assignment will receive the Caller ID information.
Semi-Automatic mode
When a call comes in, the first ring of a call passes directly to the Primary port. Between the first and second rings, the Caller ID
will display its information, and the call is then processed normally. NOTE: If Distinctive Ring Service Detection is turned
ON, the second ring will be processed as described in "Distinctive Ring Service." Only the port designated by the DRS
Assignment will receive the Caller ID information.
The factory setting for Caller ID Retransmission is ON. Caller ID Pass Thru must be OFF before this feature is turned ON.
To turn this feature ON:
1. Take the phone in port P1 off-hook
2. Press # * (three beeps) 1 1 8 * (three beeps) * (one beep)
3. Hang up the phone
To turn this feature OFF:
1. Take the phone in port P1 off-hook
2. Press # * (three beeps) 0 1 8 * (three beeps) * (one beep)
3. Hang up the phone
═════════════════════════════════════════════════════════════════
Operating Mode
The Operating mode can be set in either the Automatic mode or the Semi-Automatic mode as previously described.
The factory setting is for operation in the Automatic mode [ # * (three beeps) 2 0 * (three beeps) ]
To set the ASAP 104 for Semi-Automatic mode, perform
the following steps:
1. Take the phone in port P1 off-hook
2. Press # * (three beeps) 2 1 * (three beeps) * (one
beep)
3. Hang up the phone
To set the ASAP 104 for Automatic mode, perform the
following steps:
1. Take the phone in port P1 off-hook
2. Press # * (three beeps) 2 0 * (three beeps) * (one
beep)
3. Hang up the phone
30
Advertisement
Table of Contents
