Table of Contents
Advertisement
═════════════════════════════════════════════════════════════════
Caller ID Pass Thru
This feature allows Caller ID devices to be connected directly to the Primary port of the ASAP 104.
Operates in either the Automatic mode or the Semi-Automatic mode. (Caller ID requires service activation from the phone
company.) Also see the Caller ID Retransmission section.
Operation in the Automatic mode and Semi-Automatic mode vary as follows:
Automatic mode
When the ASAP 104 is in the Automatic mode, the first ring of a call passes directly to the Primary port. Between the first and
second rings, the Caller ID will display its information. The ASAP 104 answers the call before the start of the second ring and
processes the call normally. All extensions phones will ring. If Distinctive Ring Service Detection is turned ON, only the
primary port will receive the Caller ID information even if the primary port is not the designated port for the distinctive ring
pattern. The second incoming ring will be processed as described in "Distinctive Ring Service."
Semi-Automatic mode
In this mode, Caller ID is always ON. When a call comes in, the first ring of a call passes directly to the Primary port. Between
the first and second rings, the Caller ID will display its information, and the call is then processed normally. NOTE: If
Distinctive Ring Service Detection is turned ON, the second ring will be processed as described in "Distinctive Ring Service."
The factory setting for Caller ID Pass Thru is OFF. Caller ID Retransmission must be OFF before this feature is turned ON.
To turn this feature ON:
1. Take the phone in port P1 off-hook
2. Press # * (three beeps) 1 1 4 * (three beeps) *
(one beep)
3. Hang up the phone
═════════════════════════════════════════════════════════════════
Emergency Call Override Action
Operates in either the Automatic mode or the Semi-Automatic mode.
This feature allows the Emergency Call Override feature to operate the phone company's 3-way calling service.
See Emergency Call Override for operating procedures with the ASAP 104.
The factory setting for Emergency Call Override is set to go on-hook for 2.2 seconds [# * (three beeps) 0 1 5 * (three beeps) *
(one beep) ]
To set the ASAP 104 for operation with the 3-way calling feature (ASAP 104 performs a flash), use the following steps:
1. Take the phone in port P1 off-hook
2. Press # * (three beeps) 1 1 5 * (three beeps) * (one beep)
3. Hang up the phone
To set the ASAP 104 to go on-hook for 2.2 seconds, use the following steps:
1. Take the phone in port P1 off-hook
2. Press # * (three beeps) 0 1 5 * (three beeps) * (one beep)
3. Hang up the phone
To turn this feature OFF:
1. Take the phone in port P1 off-hook
2. Press # * (three beeps) 0 1 4 * (three beeps) *
(one beep)
3. Hang up the phone
29
Advertisement
Table of Contents
