Port Tone Assignment; Emergency Call Override - Command Communications ASAP 104 Installation And Reference Manual

═════════════════════════════════════════════════════════════════

Port Tone Assignment

Operates in either the Automatic mode or the Semi-Automatic mode.
This feature designates where the ASAP 104 will transfer a call that produces the following identifying tones:
The tones can be set to transfer automatically (depending on operating mode) to any port on the ASAP 104.
The ASAP 104 looks for a 4-digit code to set the port designations for receiving tone transfers. The first digit represents port
P1, the second digit represents port P2, the third digit represents port P3, the fourth digit represents port P4. The ASAP 104
cannot be set to transfer any tone to more than one port.
Following are the digits that represent the tones for setting port designations:
0 No tone assigned
1 1100Hz CNG
2 1300Hz modem calling tone
3 1100Hz & CNG 1300Hz modem calling tone
The factory setting for Port Tone Assignment is [ # * (three beeps) 3 0 0 1 2 0 * (three beeps) * (one beep) ].
To change this feature, perform the following steps:
1. Take the phone in port P1 off-hook
2. Press # * (three beeps) 3 0 _ _ _ _ * (three beeps) * (one beep) (blank spaces represent selection of tones)
3. Hang up the phone
═════════════════════════════════════════════════════════════════

Emergency Call Override

This feature allows the Primary port to interrupt a call in process on another port and operates in either the Automatic mode
or the Semi-Automatic mode.
Emergency Call Override is capable of operating with the phone company's three-way calling service (Emergency Call
Override Selection).
Operation of this feature is provided through the Primary port, and can be set for automatic or manual operation.
Automatic operation
When a call is in process on a port and a phone connected to the Primary port goes off-hook, the ASAP 104 will
automatically release the line as described in "Using the ASAP 104."
Manual operation
When a call is in process on a port while a phone connected to the Primary port goes off-hook and the # key is
pressed and released, the ASAP 104 will automatically release the line as described in "Using the ASAP 104."
The factory setting for Emergency Call Override is OFF [# * (three beeps) 3 1 0 * (three beeps) * (one beep) ].
To set the ASAP 104 for Automatic Emergency Call
Override, perform the following steps:
1. Take the phone in port P1 off-hook
2. Press # * (three beeps) 3 1 2 * (three beeps) *
(one beep)
3. Hang up the phone
•
1100Hz Fax CNG tone (if turned ON)
•
1300Hz modem calling tone (if turned ON)
To set the ASAP 104 for Manual Emergency Call
Override, perform the following steps:
1. Take the phone in port P1 off-hook
2. Press # * (three beeps) 3 1 1 * (three beeps) *
(one beep)
3. Hang up the phone
31