Table of Contents
Advertisement
14.
#539/549 WINDSOR ARCH CAST FRONT INSTALLATION
14.1 All Windsor Arch fronts mounted to 922 fireboxes require a
540 WDK wireguard and mounting hardware, see fig 23.
Note – Bottom of Firebox must be installed flush with the
finished hearth height or casting will not install properly.
Castings must rest on secure hearth or floor as the
firebox and brackets will not support castings on their
own
14.2 Install mounting brackets and burner tray cover to the firebox
( see fig 24)
14.3 Install black Canopy Shield to cover openings in cast iron
canopy ( see fig 25 ). Lay inner cast front face down on the
floor. Insert one corner of the shield into the corner behind
the cast frame as shown. Bend the canopy shield to a slight
radius while inserting the other corner behind the cast frame
as shown ( it may be necessary to loosen or remove one or two of the canopy bolts). With both corners behind the cast
frame, snap the shield forward to follow the curve of the cast
iron canopy. The top of the shield should fit under the
projecting ledge in the casting as shown.
14.4 Fasten top filler piece to back side of Cast Arch ( see fig 26 )
14.5 Mount cast arch to brackets on firebox as shown in fig 27.
14.6 Hang inner casting on the outer arch and install wireguard as
shown in fig 27.
Fig 25 ,Canopy Shield Installation
Fig 27 , Mounting Cast Arch to Firebox.
Fig 23 , 540 WDK Components
Fig 24 , bracket and burner tray cover installation
Fig 26 , Top filler installation
15 of 19
Advertisement
Table of Contents
