Table of Contents
Advertisement
Please read the safety information and notes on page 3.
16.1. Operating Your Fire
The operating instructions are also on a chained plate inside the control access door.
1.
For your safety this appliance is fitted with a flame supervision device which will shut off the gas supply if, for any
reason, the pilot flames go out. This device incorporates a fixed probe, which senses the heat from the pilot flame. If the
probe is cool, the device will prevent any gas flow unless the burner control knob is kept pushed in at the PILOT position.
See full lighting instructions on next page.
2.
The Valor Remote Control System
Your Valor Remote Control helps you get the comfort, convenience and aesthetics you want from your Valor Gas Fireplace.
a.
Press either of the large "up" or "down" buttons.
b. To raise the flame, press and hold the "up" button until you come to the flame level you want. Let go.
c.
To lower the flame, press and hold the down button until you come to the flame you want. Let go.
d. The flame level will remain just as you set it.
3.When first turned on, the decorative flames will appear predominantly blue. After approximately 15 minutes the flames will
turn yellow.
16.2. Cleaning
Turn the fire off and allow it to cool before attempting any cleaning. Note that the fire will retain heat for some time after it
has been turned off.
Metal parts
Clean the metal parts with a slightly damp cloth and then dry. Do not use abrasive cleaners, they could scratch the surface.
Coals and ceramic firebox walls
Dust etc. Can be brushed from the coals using a soft bristle paintbrush after removing the safety guard. We suggest that you
remove the coals in the reverse order to that shown in fitting instructions. Make sure that no particles are brushed into the
ceramic burner slots.
16. OWNERS INFORMATION
Setting the Flame
17 of 19
Advertisement
Table of Contents
