1. Carefully lift the casting. Place it against the
fireplace front surface so that the retaining strip
at the back of the casting is above the two upper
retaining brackets at the top of the convection box.
2. Lower the casting making sure that the rear
retaining strip locates fully over the retaining
brackets on the convection box—see figure below.
1. Locate the guard bottom wires over the ash lip.
2. Hold the top springs down and swing the guard
back.
3. Release the springs so that they locate behind the
canopy—see figures below.
923ACF Adorn Cast Front Installation
Adorn Safety Guard Fitting
3. Slide the front casting/surround sideways, if
necessary, to align the bottom fixing holes with
those in the convection box. Fix the bottom of the
casting/surround to the convection box with two
screws—see figure below.
15
15