Section 5 - Electrical Interfaces; Dmd2401 Connections; Ac Power Input/Switch; Dc Power Input/Switch - Radyne DMD2401 Operation Manual

Table of Contents

DMD2401/DMD2401L/DMD2401 IBS/IDR Satellite Modem

All DMD2401 connections are made to labeled connectors located on the rear of the unit: The

connector definitions below are those on the DMD2401 unit. Any connection interfacing to the

DMD2401 must be the appropriate mating connector.

The AC Power Entry Module (Figure 5-1) is located at the left side of the unit (as viewed from the

rear). Primary power applied to the port with the supplied power cable is 10 – 240 VAC, 50 – 60

Hz. Integrated into the power entry module is the Power On/Off Rocker Switch. Power

consumption for the unit is 1 A. The power cord/connector assembly is a supplied item.

A chassis ground connection (size 10-32 thread) stud, is located to the lower right of the AC

Power Cord.

The Optional DC Power Input and Switch (Figure 5-1) is available for all DMD2401 products. The

unit may be powered from a 36 – 75 VDC source with a maximum unit power consumption of 3

A.. Refer to Table 5-1 for pinouts.

Table 5-1. DC Power

Ground

TM065 - Rev. 3.3

Section 5 – Electrical Interfaces

–

Electrical Interfaces

5-1

Table of Contents