Adaptation To The Arm Length; Footrest - Otto Bock SKIPPI User Instructions

9.4.2 Adaptation to the Arm Length

After loosening the attachment screws on the bottom of
the armrest, the control panel can be shifted forwards or
backwards and can thus be adjusted to the desired arm
length (Fig. 20).

9.4.3 Footrest

Fig. 20
The footrest is easy to remove. As shown in the photo (Fig.
21), you just have to press the safety pin and remove the
footrest by pulling it up. For mounting, put the footrest from
above in the holding device, press the pin and turn the
footrest until it engages.
By loosening the screws on the telescoping footrest tube
at the front and rear, the footplate can be adapted to the
lower leg length and to the thickness of the child's seat
Fig. 21
cushion (Fig. 21).
The angle of the footplate can be changed by loosening
the attachment screw on the rear of the footrest bar (Fig.
22).
The footrest receivers can be telescoped in longitudinal
and transverse direction. Telescoping in longitudinal
direction takes place in pairs: Loosen both screws and
Fig. 22
70