Otto Bock SKIPPI User Instructions page 35

The current state of the charging process is indicated by
the LEDs of the battery charger:
Charging Charging
ON LED
indicator 1 indicator 2
On On Off
On Off On
On On On
On Off Off
On Off Off
Off Off Off
The battery charger features a programmed recharging
phase. Once the battery is completely charged, the battery
charger can remain connected with no risk of overcharging
or damaging the battery. When the charging process is
complete, first disconnect the battery charger from the mains
supply and then from the control panel.
After removal of the battery charger the drive stop is no
longer active and the Skippi is ready for driving.
Error LED Function
Off Charge < 80%
Off Charge > 80%
Off Charge 100%
Off Error 1
On Error 2
Off Error 3
Troubleshooting
Error Cause
1.Battery The battery is
connection is unconnected, the
missing battery terminals/
plug is/are dirty, or
the connection to
the battery cables
is interrupted.
2. General Wrong pole con-
function fault nection of the
battery, battery
charger fault and/
or battery fault.
3. Supply line There is no input
fault voltage on the bat-
tery charger.
If you do no manage to eliminate the faults with the measures
mentioned above, please contact your authorized dealer.
Solution
Check the plug,
cable and pos-
sibly the fuse of
the batteries.
Contact your au-
thorized dealer.
Check the supply
line and wall so-
cket.
87