Error Indication - Control For Attendant; Control Panel, Swing-Away; Lap Belt - Otto Bock SKIPPI User Instructions

Control via the hand control device is no longer possible
now. Only the On/Off button for turning the control off
remains active. After turning off, the control can be turned
on again with both, the hand control device and the control
for attendant. If the control is turned on with the control for
attendant, the display of the hand control device remains
inactive.
13.1.8 Error Indication – Control for Attendant
With three colors and different flashing codes, the mode
LED indicates the status of speed level and system errors.
Mode LED
Red flashes once
Red flashes twice
Red flashes three times
Red flashes four times
Red flashes five times
Error/warning
Control unit fault
Hand control device fault
Communication error
Joystick warning
Brake/motor fault

13.2 Control Panel, Swing-away

To allow the user to drive closer to a table or even below the
edge of a table, the control panel can be swung to the side
with a special control panel holder. A light pressure from
the side on the control panel body will disengage the holder
which now can easily be swung to the rear in parallel. It can
be swung away up to the armrest. When bringing the control
panel back to its original position, the pivot element re-enga-
ges. (Technical revision is currently being prepared.)
13.3

Lap Belt

The Skippi can be equipped with a lap belt. The lap belt
serves exclusively as a safety belt when driving the power
wheelchair for children. The belt must never be used as
a safety belt for the user when being transported in the
wheelchair in a motor vehicle.
97