Otto Bock SKIPPI User Instructions page 12

Please observe the following order for disassembly:
1. Remove the footrests (Fig. 5).
2. Take off the control panel and carefully deposit it on the
ground beside or behind the wheelchair (Fig. 6).
3. Remove the side panels (Fig. 7).
4. Fold the backrest down to the front (possible only with
manual back adjustment) (Fig. 8).
5. Loosen the drive unit from the seating unit by
simultaneously pulling the hook and loop strap and
folding the locking bar to the rear (Fig. 9).
7. To separate the frame from the drive unit sustainer, step
on one of the bumper wheels above the anti-tippers so
that the anti-tippers touch the ground (Fig. 12).
Then separate the frame from the drive unit sustainer by
slightly lifting the frame and pulling it to the rear.
To reduce the space needed, the two battery packs can
be replaced into the drive unit sustainer. To prevent the
battery packs from falling out of the drive unit sustainer,
the locking lever must be relocated (Fig. 10).
The control panel can be put on the battery packs (Fig.
11).
64
Fig. 7
Fig. 9
Fig. 11
Fig. 8
Fig. 10
Fig. 12