Table of Contents
Advertisement
Start Up / Shut Down
Procedures
STEP
PROCEDURE
1
Turn on the power:
a.
Press the POWER button on the transceiver.
The transceiver starts up and the STATUS lamp
glows GREEN - this can take up to 30 seconds.
b.
Turn on the computer.
In standard installations, the WMB-160/80F
program self loads.
The program then performs a self-calibration
(STBY button turns YELLOW). When the button
turns BLUE it is ready to go.
If no dongle is found, a Dongle Error box ap-
pears on the screen.
Ensure a dongle has been plugged into the
computer's USB port and click Retry.
c.
Turn on the satellite compass according to the
manufacturer's instructions.
2
Choose a display mode:
a.
Click the window layout button representing the
screen layout you require:
Single.
2-Horizontal Split Screen.
2-Vertical Split Screen.
4-Screen.
b.
Keep clicking the layout button you have cho-
sen until the display mode or modes you require
displays.
These can be re-configured in the System
Configuration Utility.
See Operator Manual OM_WMB_SYS for
details.
Note: It is usually easier to select the
display modes after you have started
transmitting, as you can see the ac-
tual modes displayed.
Doc. P/N:
WSP-009-002
Version:
V2.3
Issue Date:
July 2014
Installation Manual
SCREEN
STATUS
You can click Cancel and run a demo file from the System
Configuration Utility.
SINGLE
2-VERTICAL
www.wassp.com
POWER
2-HORIZONTAL
4-SCREEN
Page 61 of 68
Advertisement
Table of Contents
