Table of Contents
Advertisement
Pre-commissioning
Procedures
Page 36 of 68
Installation Manual
Note: Before the Transfer Task is configured it may be necessary
to start the computer before the satellite compass.
Pre-commissioning procedures consist of ensuring the required software is loaded
and the display and network settings correctly set. This is generally only required if
the supplied computer settings have been changed or another computer installed.
Required Software
Windows XP.
►
Latest graphics drivers for your graphics card.
►
WASSP WMB-160/80F program version 50.
►
Required Display Settings
1)
If running, close the WASSP WMB-160/80F program.
Right-click in the Windows desktop and click Properties.
2)
3)
Click the Settings tab.
4)
In the Colours drop down box, set the colour to 32 bit.
Recommended Display Settings
1)
Set the screen resolution (Screen area) to 1024x768.
2)
Click the Screen Saver Tab
3)
Select Screen Saver (None).
Click the Power... button.
4)
5)
Configure the power management settings so the monitor and hard disks
never turn off automatically.
Click OK (to close the Power Options Properties box).
6)
7)
Click OK (to close the Display Properties box).
Network Settings
If using an Ethernet WMB-160/80F version you must ensure the LAN settings are
correct.
1)
In the Control Panel, open Network Connections.
2)
View the Properties of the Local Area Connection that the WMB-160/80F is
connected to.
3)
Select Internet Protocol (TCP/IP) (install if not present).
4)
Click Properties. Select Use the following IP Address and input the fol-
lowing:
IP address:
Subnet mask:
Default gateway: (leave blank).
5)
Click OK (to close this window).
6)
Click Close (to save these settings).
www.wassp.com
192.168.65.10
255.255.255.0
Doc. P/N:
Version:
Issue Date:
WSP-009-002
V2.3
July 2014
Advertisement
Table of Contents
