Table of Contents
Advertisement
Document Revision History
Revision Date
Reason for Change
12 November 2007
Updated with new software changes and addition of
Snapshot button to GUI.
4 February 2008
Modified patch test description.
9 February 2009
New version incorporating Compact Transducer and
software version 104.048 changes
7 April 2009
Detail of use with RJ-45 Type BTxR and transducer
cable with RJ-45 connectors added.
11 May 2009
Minor wording correction, detail of Shuttle PC added.
23 June 2009
New version incorporating changes for software version
104.049
9 July 2009
Updates and Backscatter Gain test added.
8 Dec 2009
Updated following release of V.50 software
2 September 2010
Updated for release of V.51 software
13 September 2010
Merged 80 and 160 Manuals into one document
28 January 2011
Updated to comply with latest V.51 features
30 November 2011
Updated figures and specs
12 January 2012
Updated Figures 7 and 11
27 June 2012
V52 updates.
4 July 2014
V52.5 Updates
Related Documents
Document P/Number
Title
WSP-009-001
WASSP System Operator Manual
General Notices
WASSP Ltd. reserves the right to change the contents
of this manual and any system specifications without
notice.
Contact WASSP Ltd. regarding copying or reproducing
this manual.
The WMB-160/80F is not designed to comply with hy-
drographical mapping standards and therefore must not
be used as a navigational mapping tool.
Warnings, Cautions, and Notes
Warnings, cautions, and notes are indicated by the
following icons throughout this manual:
A WARNING indicates that if the
instruction is not heeded, the action may
result in loss of life or serious injury.
A CAUTION indicates that if the instruction
is not heeded, the action may result in
equipment damage or software corruption.
A Note indicates a tip or additional infor-
mation that could be helpful while perform-
ing a procedure.
Page 2 of 68
Installation Manual
www.wassp.com
Version
V1.2
V1.3
V1.4
V1.41
V1.42
V1.5
V1.51
V1.6
V1.7
V1.8
V1.9
V2.0
V2.1
V2.2
V2.3
Safety Notices
The installer of the equipment is solely responsible for
the correct installation of the equipment. WASSP Ltd.
assumes no responsibility for any damage associated
with incorrect installation.
Electrical Safety
► Fire, electrical shock, or equipment damage may occur if
the transceiver becomes wet.
► The equipment is rated for operation at:
• Transceiver: 24 V DC.
• WASSP Ltd. supplied computer: 230 V AC.
► Make sure that the power is switched OFF at the main
supply (e.g. switchboard) before beginning the installation.
Fire or electrical shock may occur if the power is left ON.
► Do not open equipment covers unless you are totally
familiar with the system's electrical circuits.
► Make sure all safety precautions for electrical equipment
are taken when operating or servicing the equipment.
These to be carried out in accordance with local or na-
tional regulatory body safety regulations.
► Make sure that the transducer will not loosen due to the
vessels vibration.
Doc. P/N:
Version:
Issue Date:
WSP-009-002
V2.3
July 2014
Advertisement
Table of Contents
