Table of Contents
Advertisement
Page 52 of 68
Installation Manual
Commissioning Step 8: Tide Configuration
Use the System Configuration Utility Tides page to enable Tide Correction. Tide
calculation requires Position and Time, if these are not present the entire Tide
page will be blank. Check that the Current Time reads as the Current Local Time.
If not enter a number in the Local Time Adjustment until the Current Time is the
same as the Local Time, this number will be the Time Difference of your current
location from UTC time. e.g. +12 for New Zealand.
The system is now ready for sea trial commissioning procedures. This
requires the vessel to leave the dock and perform some basic manoeuvres.
The deeper the water the more accurate the tests can be. Aim for at least 20
metres of water.
www.wassp.com
Doc. P/N:
WSP-009-002
Version:
V2.3
Issue Date:
July 2014
Advertisement
Table of Contents
