Table of Contents
Advertisement
Drawing not to scale
All sizes in millimeters
Doc. P/N:
WSP-009-002
Version:
V2.3
Issue Date:
July 2014
Installation Manual
Inverter
Outline and Dimensions
Figure 10 shows the physical dimensions of the optional WASSP Ltd. supplied
inverter. If installing the inverter, carefully read the supplied manufacturer's user
manual and install and operate the inverter accordingly ensuring the environment
is:
1)
DRY –
Do not allow water to drop on or enter the inverter.
2)
COOL – The ambient air temperature should be between 0°C and 33°C
- the cooler the better.
3)
SAFE – Do not install the inverter in a battery compartment or other areas
where flammable fumes may exist, such as fuel storage areas or engine
compartments.
4)
VENTILATED – The inverter must be well ventilated at all times. Ensure
there is at least 25 mm of space around the inverter. Ensure the ventilation
fan and air holes are not obstructed at both ends of the inverter.
5)
DUST FREE –
dust can be drawn into the unit when the fan is operating.
6)
CLOSE TO BATTERIES –
ment as batteries. Do not mount the inverter where it will be exposed to
the gasses produced by the battery, as these are corrosive and prolonged
exposure will damage the inverter. Avoid excessive cable lengths. Use the
recommended wire lengths and sizes (detailed in Section 3-6 of the user
manual).
7
35
Figure 10 – Inverter Mounting Bracket Outline and Dimensions
www.wassp.com
Do not install the inverter in a dusty environment as the
Do not install the inverter in the same compart-
SIDE VIEW
PURE SINE WAVE INVERTER
ON
OFF
REMOTE
AC OUTPUT
180
TOP VIEW
37.5
273
308
INPUT
LEVEL
LOAD
LEVEL
STATUS
72
FREQ.
S4
S3
PWR.
S2
SAV.
S1
166 180
7
37.5
Page 17 of 68
Advertisement
Table of Contents
