Table of Contents
Advertisement
The transceiver can be mounted with
the transducer cable feeding in from
the top. WASSP Ltd. do not recom-
mend this as any water leaks could
run down any of the cables attached to
the faceplate and enter the transceiver.
Page 22 of 68
Installation Manual
Installation Manual
Mounting Instructions – Transceiver
Transceiver Installation Considerations
For maintenance purposes, the PCB assembly can be removed from the case in
situ. Always leave at least 600 mm clearance at the faceplate end cover to allow
the PCB assembly to be withdrawn from the case.
Transceiver Installation
Using the mounting flanges on the end covers, the transceiver can be mounted
vertically on a bulkhead, or horizontally on the floor. See Figures 5 and 13 for
transceiver dimensions and mounting clearances.
1)
Using the mounting holes on the mounting flanges, secure the transceiver to
the mounting surface.
2)
Connect the following cables to the faceplate end cover. See Interface
Connections for cable connection details:
• Transducer cable to Transceiver. See page 25 for details.
• Personal Computer CAT5 cable to Transceiver
• 24V DC power to Transceiver
Horizontal Floor Mounting
535
Figure 13 – Transceiver Mounting Diagram
www.wassp.com
Vertical Bulkhead Mounting
Mounting
holes
80
Drawing not to scale
All sizes in millimeters
Doc. P/N:
Version:
Issue Date:
221.5
172
535
497
WSP-009-002
V2.3
July 2014
Advertisement
Table of Contents
