Table of Contents
Advertisement
19
Page 12 of 68
Installation Manual
Outline Diagrams
The outline diagrams in Figures 6 to 9 provide the physical dimensions of the
internal items of equipment to be installed.
Transducer Mounting Dimensions
The diagrams on page 65 / 66 provide physical dimensions of transducers.These
sizes are required by the installing shipyard to construct a sea chest to mount the
transducer to the hull.
Note: Use the sizes in this diagram to assist in the manu-
facture of the sea chest and transducer backing plate.
Transceiver Mounting Dimensions
Figure 5 shows the physical dimensions of the transceiver. The hole centres on the
mounting brackets are required for mounting the transceiver.
SIDE VIEW
456
535
497
TOP VIEW
Drawing not to scale
All sizes in millimeters
Figure 5 – Transceiver Outline and Mounting Bracket Hole Centres
www.wassp.com
TRANSDUCER
(Transmitter)
EARTHING STRAP
24.5
TRANSDUCER
172.5
(Receiver)
19
Doc. P/N:
Version:
Issue Date:
FRONT VIEW
24V STATUS POWER
WASSP PC SENSOR
Grey
Blue Green Yellow Orange Red
Black
221.5
WSP-009-002
V2.3
July 2014
180
Advertisement
Table of Contents
