Table of Contents
Advertisement
The default is to have Direct X and
8
BTxR selected. If you have the
BTxR selected, ensure it is tuned on
and connected.
Click Finish
Install DirectX
9
Click I accept the agreement
and then follow instructions.
After DirectX is installed, the
10
BTxR Software will update.
If you get the following error, start the
Transfer Task and click Retry.
1)
Right-click the Serial Transfer Task icon on
the Windows Task bar.
2)
Click Setup.
The Serial Transfer Task box opens.
3)
In the NMEA Settings and WASSP Settings
tabbed page configure the Network Setup
and NMEA Com Port Settings.
Note: If the Serial Transfer Task icon is
not available on the Task Bar, click Start >
Programs > WASSP WMB160/80F Transfer
Task.
Page 32 of 68
Installation Manual
www.wassp.com
1
2
Doc. P/N:
Version:
Issue Date:
WSP-009-002
V2.3
July 2014
Advertisement
Table of Contents
