Installing A Power Supply; Figure 2-21 The Res-Xr4-1U Power Supply Locking Mechanism - Themis RES-XR4-1U Installation Manual

RES-XR4-1U Installation Manual
Push locking lever to
the right and remove
power supply
Power Supply
Locking Lever
Phillips Screw Hole
for knurled captive screw
on power supply
locking bracket
2.2.3

Installing a Power Supply

Perform the following steps to install a power supply:
2-26
4. Put the right index finger on the power supply extraction handle and the right
thumb on the left side of the power supply locking lever (see Figure 2-21).
5. Squeeze the locking lever toward the extraction handle and firmly pull the
power supply from the chassis.
Caution: When pulling the power supply from the chassis, hold it at the bot-
tom to prevent it from falling and damaging the unit.
Extraction
Handle
Figure 2-21.
The RES-XR4-1U Power Supply Locking Mechanism
1. Insert the replacement power supply into an empty slot with the power LED
at the top (see Figure 2-21).
2. Push the power supply carefully into its slot until it is firmly seated (a click
will be heard when the locking lever is securely fastened to the chassis).
3. Re-install a Power Cord Retention Bracket to securely hold the power sup-
plies in place.
System-Power LED
Power Supply
AC Outlet Locking Lever
Version 1.5
Phillips Screw Hole
for knurled captive screw
Themis Computer