Attach I/O Cables; Usb Ports A And B - Themis RES-XR4-1U Installation Manual

D.1.1
J10 Connected to any available USB header
J8 Connected to any available Serial header
J1 Connected to any available USB header*
J2 Connected to an audio connector on the
rear of the chassis (Line Out)
J4 Connected to an audio connector on the
rear of the chassis (Line In)
* The RES Custom Module contains an
Audio chip on its PCB, routed to J1.
PCB (Printed Circuit Board)
Attach the appropriate
I/O Cables from the
RES Custom Module
to external devices.
Themis Computer

Attach I/O Cables

Figure D-3 shows the three types of I/O supported by the RES Audio/USB/Serial
Port Custom Module:
• USB Port A and Port B
• One Serial Port
• One optional Stereo Audio Jack (installed only by customer request)
Figure D-3 also shows the header connectors that are routed by cable through the
empty drive slot into the RES system for connection to the proper RES motherboard
surface headers or optional rear audio connectors.
To RES Motherboard surface (top-side) headers
J11
Port A

USB Ports A and B

Figure D-3.
Serial
USB
Header
Header
J10 J8
Port B
J9
DB9 Serial Port
Attach the Appropriate I/O Cables
D—Optional RES Audio/USB/Serial Port Module
RES Audio/USB/Serial Port Custom Module
To Rear of Chassis
USB to
Audio Out
Audio Chip
(Line Out)
J1
J3
Stereo Audio Out Jack (Optional)
(Optional)
Audio In
(Line In)
J2
J4
D-3