Themis RES-XR4-1U Installation Manual page 10

RES-XR4-1U Installation Manual
6. Turn off power and input signals before inserting and removing connectors or
test equipment. Power is not considered off until all power supplies have been
disconnected.
7. Keep the work area free of non-conductive materials such as ordinary plastic as-
sembly aids and Styrofoam.
8. Use field service tools, such as cutters, screwdrivers, and vacuums that are con-
ductive.
9. Always place drives and boards PCB-assembly-side down on the foam.
10. Grounding wire size shall be no less than 16 AWG.
11. Overcurrent Protection relies on proper building installation and Earth connec-
tion (ground).
12. High Voltage; Earth connection is essential before connecting the power supply
units
Instructions for the Lithium Battery
Systems are equipped with a lithium battery installed on the motherboard. To
replace this battery, please observe the instructions that are described in this man-
ual.
Follow all local guidelines and regulations for disposing of used batteries .
Note: Switzerland: Annex 4.10 of SR 814.013 applies to standard batteries.
viii
Warning: There is a danger of explosion when the wrong type of battery is used
as a replacement.
Warning: There is a danger of explosion if attempting to recharge the lithium
battery installed on the motherboard.
Version 1.5
Themis Computer