Turn Off The Projector; Information; Network Control Instructions; Lan Control - Eiki EK-100W Owner's Manual

Information

The information menu is used to the detect signal of projected image and running state.
Menu operation
Press MENU button on the remote control or
top control to display the screen menu. Press
 to select Info., the information menu will
appear as the right picture.
T h e i n f o r m a t i o n b e l o w w i l l d i s p l a y i n
information menu.
Input
The selected input source is displayed.
H-sync freq .
The horizontal frequency of the input signal is
displayed in KHz or - - - -KHz when no signal is
detected.
V-sync freq .
The vertical frequency of the input signal is
displayed in Hz or - - - - Hz when no signal is
detected.
Lamp status
The setting status of "Lamp control" is
displayed.
Lamp counter
The usage time of the lamp is displayed.
Power management
The setting status of "Power management" is
displayed.
Image mode
T h e s e t t i n g s t a t u s o f " I m a g e m o d e " i s
displayed.
52
info. menu
Info.
Input Computer 1
1024 x 768, 60Hz
H-sync freq. 48.24 kHz
V-sync freq. 60.06 Hz
Lamp status
Lamp counter 2 H
Power management Ready
5 Min
Image mode Standard

Network Control Instructions

LAN control

Function : PC controls projector via LAN.
Preparation:
1. Equipments: PC, projector, cables
2. Connection procedures:
Connect the projector to routers or switches of the LAN by direct or cross cable. If it fails to
connect PC and projector by parallel cable, please switch to cross cable as suggested.
3. After the computer is booted and the projector is plugged in, indicator lights of LAN interface
and computer interface will flash continuously.
Operation procedures:
1 Turn on the projector.
2 Obtain network address. DHCP set is displayed as on and obtain network address
automatically. If familiar with network, you can set DHCP as close and obtain network
address manually.
3 Enter network settings menu.
(1) Press MENU button on top control
or remote control to display screen
menu. Press ▲▼ button to select
"Expand" icon, then press the OK button.
(2) Press ▲▼ button to select "Network"
setting and press the OK button enter
the network setting.
(3) Press ▲▼ button to set DHCP as on.
(4) Press ▲▼ button to "Set" and press
the OK button."Please wait..." appears.
 Note:
● When connecting to wireless network,please check the SSID/ ESSID and IP address in
"Network information" .
Expend
Network
Network setting
Network information
MAC address
7C 6F F8 4E 48 A8
IP address 192.168.1.100
LAN
Network setting
DHCP On
IP address
Subnet
Gateway
DNS
Set
Cancel
Adjust Select Back
Esc
ENTER
53