Modulation Delay - Korg RK-100S Parameter Manual

See page 40 "LFO KeySync"
LFO Init Phase
Sets the starting location of the waveform
Note: This parameter will be displayed and can be set if "LFO KeySync" is On.
See page 41 "LFO Init Phase"
LFO Spread
Sets the phase difference between the left and right channels
High Damp
Sets the damping amount in the high range
Trim
Sets the input level

Modulation Delay

This is a stereo modulation delay.
Stereo In - Stereo Out
Left
Delay
Delay
Right
LFO
Dry/Wet
Sets the balance between the effect and dry sounds
Delay Tempo Sync
See page 44 "Delay Tempo Sync"
[000...180°]
[–180...+180°]
[000...100%]
[000...127]
Dry / Wet
Feedback
Dry / Wet
LFO Spread
[Dry, 99:1...1:99, Wet]
[Off, On]
Time Ratio
Delay Tempo Sync On: 12.5...400.0%]
See page 45 "Time Ratio"
L Delay Time
R Delay Time
See page 45 "L Delay Time, R Delay Time"
Feedback
See page 45 "L Delay Time, R Delay Time"
Mod Depth
Sets the depth of LFO modulation
LFO Frequency
Sets the LFO speed
Increasing this value will result in a faster frequency.
See page 40 "LFO Frequency"
LFO Spread
Sets the phase difference between the left and right channels
Effect guide
[Delay Tempo Sync Off: 0.5...400.0%/
[000...1400msec, 1/64... 1/1]
[000...1400msec, 1/64... 1/1]
[000...127]
[000...127]
[0.01...100.0Hz]
[–180...180°]
47