Oscillator2 - Korg RK-100S Parameter Manual

RK-100S parameter guide
7. When Wave: Saw, Pulse, Triangle, Sine and OSC1 Mod: Unison
CONTROL1: Detune (Unison Detune)
This parameter adjusts the difference in pitch between the five unison oscillators.
Higher values will broaden the pitch difference between the oscillators, producing
a richer sound.
CONTROL2: Phase (Oscillator Phase)
Specifies the phase of each oscillator at note-on. This will affect the tone of the
attack. A setting of 127 will change the pitch and volume.
000 (0º)
Saw
Pulse
Triangle
Sine
14
[000...127]
[000...127]
063 (90º) 127 (180º)
8. When Wave: aw, Pulse, Triangle, Sine and OSC1 Mod: VPM
CONTROL1: Mod Depth (VPM Depth)
Adjusts the depth of VPM
CONTROL2: Harmonics (Mod Harmonics)
Specifies the frequency of the VPM modulator as a harmonic multiple of oscillator 1

OSCILLATOR2

Here you can adjust the settings for oscillator 2. By using this in conjunction with
oscillator 1 you can obtain a variety of sounds. For example by adjusting OSC2
SEMITONE and OSC2 TUNE, you can make one oscillator act as an overtone
of the other oscillator. Alternatively, you can create a musical interval by setting
each oscillator to a different pitch, or create a detuned effect by setting the two
oscillators to slightly different pitches. You can also apply ring modulation or
oscillator sync to generate complex overtones (this is done using the OSC2 "OSC
MOD" parameter).
WAVE
Selects a waveform for oscillator 2.
Saw: A sawtooth wave.
PULSE: A square wave.
Triangle: A triangle wave.
Sine: A sine wave.
If you do not hear the sound of oscillator 2, go to the MIXER and raise "OSC2". If
you want to hear only the sound of oscillator 2, lower the "OSC 1" on the MIXER.
[000...127]
[001...032]
[Saw, Pulse, Triangle, Sine]