Korg RK-100S Parameter Manual page 55

Keytar
Hide thumbs Also See for RK-100S:
Table of Contents

Advertisement

Duration Tempo Sync
Specifies whether playback of the looped waveform will be synchronized
If this is ON, the looped waveform will play in synchronization with the tempo
specified by the TAP button or the MIDI clock.
Time Ratio
[Duration Tempo Sync Off: 0.5...400.0%/
Duration Tempo Sync On: 12.5...400.0%]
This specifies the length of the looped waveform relative to the "Duration" value
Duration
Sets the duration of the grain
The length of the waveform is determined by this setting and the "Time Ratio"
setting.
If "Duration Tempo Sync" is Off, this is set in msec units.
If "Duration Tempo Sync" is On, this is set as a timing resolution relative to the
tempo specified by the TAP button or the MIDI clock.
If the "Duration" and "Time Ratio" settings would cause the allowable range to be
exceeded, the length of the waveform will be set to the maximum possible setting.
LFO Tempo Sync
Specifies whether the LFO cycle will be synchronized with the tempo specified
by the TAP button or MIDI clock
See page 40 "LFO Tempo Sync"
LFO Frequency
If "LFO Tempo Sync" is Off, this specifies the cycle at which the waveform is
switched in Hz units.
The waveform length specified by the "Duration" parameter will play as a loop,
and the waveform will switch at each cycle of the LFO.
[Off, On]
[000...350ms, 1/64... 1/1]
[Off, On]
[0.01...100.0Hz]
LFO Cycle
Duration
In
Out
If this parameter is assigned to the "Long Ribbon (Filter)", it can be switched
to "LFO Sync Note" if "LFO Tempo Sync" is On.
LFO Sync Note
Sets the LFO frequency as a proportion of the tempo specified by the TAP button
or the MIDI clock
Note: This parameter will be displayed and can be set if "LFO Tempo Sync" is On.
See page 40 "LFO Sync Note"
LFO KeySync
Specifies whether the LFO will be reset by note-on
See page 40 "LFO KeySync"
LFO Init Phase
Sets the starting location of the waveform
Note: This parameter will be displayed and can be set if "LFO KeySync" is On.
See page 41 "LFO Init Phase"
Effect guide
LFO Cycle /Duration
[8/1...1/64]
[Off, On]
[000...180°]
55

Advertisement

Table of Contents
loading

Table of Contents