Table of Contents
Advertisement
RK-100S parameter guide
Filter 1 KeyTrack
FILTER1 "KEY TRACK"
Filter 2 Resonance
FILTER2 "RESONANCE"
EG1 Filter 2 Int.
FILTER2 "EG INT"
Filter2 KeyTrack
FILTER2 "KEY TRACK"
Filter EG Attack
FILTER EG "AT"
Filter EG Decay
FILTER 1 "DT"
Filter EG Sustain
FILTER EG "SL"
Filter EG Release
FILTER EG "RT"
AMP EG Attack
AMP EG "AT"
AMP EG Decay
AMP EG"DT"
AMP EG Sustain
AMP EG "SL"
AMP EG Release
AMP EG "RT"
Assignable EG Attack
ASSINABLE EG "AT"
Assignable EG Decay
ASSINABLE EG "DT"
Assignable EG Sustain
ASSINABLE EG "SL"
Assignable EG Release
ASSINABLE EG "RT"
Patch 1 Int
PATCH1 "INT"
Patch 2 Int
PATCH2 "INT"
Patch 3 Int
PATCH3 "INT"
Patch 4 Int
PATCH4 "INT"
Patch 5 Int
PATCH5 "INT"
Long Ribbon (Filter) Int
LONG RIBBON (FITER) INT
26
INT (Patch Intensity)
Specifies the depth of the effect produced by the modulation source.
With a setting of 0, there will be no modulation.
Setting example for "SOURCE" and "DESTINATION"
SOURCE [1]→DEST [2]
The FILTER EG or AMP EG will vary the pitch of the entire timbre
FILTER EG/AMP EG→Pitch
over time.
The FILTER EG or AMP EG will vary the panning over time. By setting
FILTER EG/AMP EG→Panpot
two patches to "INT" settings with the opposite (+/–) value you can create
more complex panning.
LFO 1/LFO 2→Pitch
Vibrato will be applied at the LFO1 or LFO2 frequency.
LFO 1/LFO 2→Cutoff
Wah will be applied at the LFO1 or LFO2 frequency.
LFO 1/LFO 2→Level
Tremolo will be applied at the LFO1 or LFO2 frequency.
LFO 1/LFO 2→Panpot
Auto pan will be applied at the LFO1 or LFO2 frequency.
Velocity→Level
Velocity (keyboard playing strength) will affect the volume.
Keyboard position will gradually change the pan; lower notes at
Key Track→Panpot
the left, and higher notes at the right.
The sound will move from one side to the other with pitch bend
changes or by using the short ribbon controller while the SHORT
Short Ribbon (Pitch) →Panpot
RIBBON button is lit up in red.
[–63...+63]
Advertisement
Table of Contents
