Short Ribbon; Synth Parameters; Oscillator1 - Korg RK-100S Parameter Manual

Keytar
Hide thumbs Also See for RK-100S:
Table of Contents

Advertisement

RK-100S parameter guide

SHORT RIBBON

In this section, you can specify settings for controlling the pitch and modulation
using the short ribbon controller.
SHORT RIBBON SETTING
This specifies which parameter will be controlled by the short ribbon controller
when the program is switched.
SHORT RIBBON (MODULATION) ASSIGN
This specifies the CC# that is transmitted when the modulation is controlled by
the short ribbon controller.
Note: The volume can be controlled without modulation only when CC#07 is
selected.
SHORT RIBBON (MODULATION) LOCK
This parameter will switch the lock on/off the modulation is controlled by the
short ribbon controller. When "Lock On" is selected, the modulation effect will
remain applied, even after you remove your hand from the short ribbon controller.
10

Synth parameters

OSCILLATOR1

[Pitch, Modulation]
Oscillators generate the basic waveform. Each timbre has two oscillators. In this
section you can adjust settings for oscillator 1.
[CC#00...CC#127]
WAVE
This parameter selects the waveform for oscillator 1. The Saw, Pulse (square),
Triangle and Sine are traditional waves associated with analog synthesizers
Saw: A sawtooth wave
[Lock Off, Lock On]
Pulse: A pulse wave
Triangle: A triangle wave
Sine: A sine wave
Formant: A formant wave with tonal characteristics similar to that of a human voice
Noise: Generates noise
PCM/DWGS: PCM/DWGS waveforms from acoustic instruments and digital
synthesizers
Audio In: The audio signal received at the INPUT jack will be used instead of
the oscillator
Note: Pitch-related parameters will not affect the signal received from the IN-
OSC MOD
Selects the type of modulation being applied to oscillator 1.
Note: The maximum number of playable voices may change depending on the
Waveform (Waveform Modulation): Use "Control1" to modify the shape of the
waveform.
[Saw, Pulse, Triangle, Sine, Formant,
PUT jack.
[WAVEFORM, CROSS, UNISON, VPM]
combination of "Wave" and "OSC MOD" settings.
Noise, PCM/DWGS, Audio In]

Advertisement

Table of Contents
loading

Table of Contents