Vibrato - Korg RK-100S Parameter Manual

RK-100S parameter guide
See page 40 "LFO Tempo Sync"
LFO Frequency
Sets the LFO speed
Note: This parameter will be displayed and can be set if "LFO Tempo Sync" is Off.
See page 40 "LFO Frequency"
LFO Sync Note
Sets the LFO frequency as a proportion of the tempo set by the TAP button
Note: This parameter will be displayed and can be set if "LFO Tempo Sync" is On.
See page 40 "LFO Sync Note"
LFO Waveform
Selects LFO Waveform
See page 40 "LFO Waveform"
LFO Shape
See page 40 "LFO Shape"
LFO KeySync
Specifies whether the LFO will be reset by note-on
See page 40 "LFO KeySync"
LFO Init Phase
Sets the starting location of the waveform
Note: This parameter will be displayed and can be set if "LFO KeySync" is On.
See page 41 "LFO Init Phase"
LFO Spread
Sets the LFO phase difference between the left and right channels
High Damp
Sets the feedback damping amount in the high range
50
[0.01...100.0Hz]
[8/1...1/64]
[Saw, Square, Triangle, Sine, S&H]
[–63...+63]
[Off, On]
[000...180°]
[–180...+180°]
[000...100%]

Vibrato

This effect causes the pitch of the input signal to shimmer
Stereo In - Stereo Out
Left
Right
LFO Shape
LFO
Dry/Wet
Sets the balance between the effect and dry sounds
Mod Depth
Sets the depth of LFO modulation
LFO Tempo Sync
Specifies whether the LFO cycle will be synchronized with the tempo specified
by the TAP button or MIDI clock
See page 40 "LFO Tempo Sync"
LFO Frequency
Sets the LFO speed
Note: This parameter will be displayed and can be set if "LFO Tempo Sync" is Off.
See page 40 "LFO Frequency"
LFO Sync Note
Sets the LFO frequency as a proportion of the tempo set by the TAP button
Note: This parameter will be displayed and can be set if "LFO Tempo Sync" is On.
See page 40 "LFO Sync Note"
Dry / Wet
Vibrato
Vibrato
Dry / Wet
LFO Spread
[Dry, 99:1...1:99, Wet]
[000...127]
[Off, On]
[0.01...100.0Hz]
[8/1...1/64]