Table of Contents
Advertisement
If this is On, the delay time will synchronize to the tempo specified by the TAP
button or MIDI clock.
Time Ratio
Sets each delay time as a proportion relative to the "L Delay Time," and "R Delay
Time" values
The available range will depend on whether "Delay Tempo Sync" is On or Off.
For example if "Time Ratio" is 50%, "L Delay Time" is 500 msec, and "R Delay Time"
is 1200 msec, the delay times will be 250 msec, 500 msec, and 600 msec respectively.
If the specified delay time multiplied by the "Time Ratio" exceeds the
allowable range, the delay time will be set to the maximum possible value
(see page 37 "Time Ratio").
L Delay Time
R Delay Time
These set the left and right channel delay times.
If "Delay Tempo Sync" is Off, these delay times are set in msec units.
If "Delay Tempo Sync" is On, these delay times are set as a timing resolution
relative to the tempo specified by the TAP button or the MIDI clock.
Feedback
Sets the amount of feedback for the left and right channels
The amount of feedback for the right channel is linked with the proportion of the
left and right delay times so that the decay times of the left and right channels
will stay the same.
High Damp
Sets the damping amount in the high range
Trim
Sets the input level
Spread
Sets the width of the stereo image of the effect sound
The stereo image is widest with a value of 127, and the effect sound of both
channels is output from the center with a value of 0.
[Delay Tempo Sync Off: 0.5...400.0%/
Delay Tempo Sync On: 12.5...400.0%]
[000...1400ms, 1/64... 1/1]
[000...1400ms, 1/64... 1/1]
[000...127]
[000...100%]
[000...127]
[000...127]
L/C/R Delay
This multitap delay outputs three Tap signals to the left, center, and right
respectively. You can also adjust the left and right spread of the delay sound.
Wet: Mono In - Stereo Out / Dry: Stereo In -Stereo Out
Left
Trim
+
Trim
Right
Dry/Wet
Sets the balance between the effect and dry sounds
Delay Tempo Sync
See page 44 "Delay Tempo Sync"
Time Ratio
Delay Tempo Sync On: 12.5...400.0%]
See page 45 "Time Ratio"
L Delay Time
C Delay Time
R Delay Time
These set the L, C, and R delay times
The delay time is determined by these settings and the "Time Ratio" value.
L Delay Level
C Delay Level
R Delay Level
These adjust the output level of the L, C, and R delays
Effect guide
Dry / Wet
L Delay
Level
C Delay
Spread
Level
Feedback
R Delay
Level
Dry / Wet
[Dry, 99:1...1:99, Wet]
[Delay Tempo Sync Off: 0.5...400.0%/
[0000...1400ms, 1/64... 1/1]
[0000...1400ms, 1/64... 1/1]
[0000...1400ms, 1/64... 1/1]
[000...127]
[000...127]
[000...127]
[Off, On]
45
Advertisement
Table of Contents
