Ricoh GlobalScan Administrator's Manual page 24

General Tab > Default Novell Connectivity Settings
C. Default Novell Connectivity Settings
•
Default Novell Tree
Novell Tree here, otherwise leave blank. If a Novell Tree is applied to a specific
profile, this will allow connection of different MFDs to different Novell Trees. If
entered, this data will automatically populate the corresponding field on the
MFD's login screen as well.
•
Default Novell Context
the Novell Context, otherwise leave blank. If the Novell Context is applied to a
specific profile, this will allow the connection of different MFDs to different
Novell Contexts. If entered, this data will automatically populate the
corresponding field on the MFD's login screen as well.
D. Default LDAP Connectivity Settings
If your company is using LDAP authentication, enter the appropriate LDAP settings
here.
Default LDAP
settings can be set
on a profile level
(here), but over-
ridden on a project
basis, if necessary
•
LDAP Server
here. Important: If using LDAPS, enter DNS name of the LDAPS Server or the
IP address.
•
LDAP Port
using LDAPS, enter 636 as the default port number.
•
LDAP Base DN
– If your company is using Novell authentication, enter the
– If your company is using Novell authentication, enter
– If not already entered, enter LDAP Server IP address or name
– If not already entered, enter here (default: 389). Important: If
– If not already entered, enter Base Distinguished Name.
(if applies to your configuration)
(if applies to your configuration)
TM
GlobalScan Ver. 2.0
Administrator's Guide
24