Icom IC-F5060 series Operating Manual page 9

D Direct code entry
q Durng stand-by operaton, push [TX Code Enter] to
enter the TX code edt mode.
• Code dgt for edtng blnks.
1 2 3 4
w Push [TX Code Enter] to select the desred dgt to be
edted.
• Dgt for edtng dffers accordng to the settng.
e Set the desred dgt usng [CH Up] or [CH Down].
r Push [TX Code Enter] to set the dgt, then the dgt to
the rght wll blnk automatcally.
t Repeat e and r to nput all allowable dgts.
y Push [Call] or [PTT]* to call.
* PTT call can be made only when PTT call capablty s permt-
ted.
NOTE: When no answer back s receved, the trans-
cever repeats the call 3 tmes (default) automatcally,
and "WAIT" s dsplayed durng each call. However, an
error beep sounds and "FAILED" s dsplayed when
no answer back s receved after the calls.
BIIS 1200 OPERATION
u Push [PTT] to transmt; release to receve.
i Push [Moni (Audi)] to send the 'Clear down' sgnal.
For your information
When the "UpDate" settng for the call code s enabled, the
set code s overwrtten nto the call code memory.
2
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
6