Connecting The Receiver; Receiver Operating Modes; Location / Mounting The Transmitter - DELTA DORE RADIO TYBOX PAC Installation Manual

Connecting the receiver

Connect the control wires, pass the wires
through the provided raceway or through
the pierced hole .
1
Refer to the section that deals with your
type of installation.
When the connection is made, fit the cover
and switch on the current at the circuit
breaker.

Receiver operating modes

Depending on the type of heat pump used, 2 operating
modes are possible.
Mode 1 (default)
One change-over output + 1 thermostat output
- Output 1 (terminal 4):
Change-over control of the heat pump
Contact closed = Cool
Contact open = Heat (Configuration 2-09)
- Output 2 (terminal 5):
On/Off control of the heat pump
Contact closed = On
Mode 2 (2 thermostat outputs)
- Output 1 (terminal 4): Heat mode command
- Output 2 (terminal 5): Cool mode command
1
- 8 -

Location / Mounting the transmitter

For easier use, the RADIO TYBOX can be installed:
- on a wall: at an approximate height of 1.5 m, with
screws/plugs,
- on a support: Placed on an item of furniture or a
shelf.
Screw-mounting
Mount the base with screws and
pegs suited to the support or on a
flush-mounted box, then close and
lock the unit.
Separate the unit from its
base by unlocking the
casing.
Remove the battery
cover.
- 9 -